❗️ We are glad to inform you that the new version of HashKeeper is already available for downloading. We’ve eliminated the errors and made a number of improvements you had asked us for.

New version: 1.2.13.2
Attention! Please be sure to delete the old version before installing the new one. The username, password, and serial number will remain the same.

🏆 The following modifications have been made:
- The time display according to the users’ time zones has been corrected
- Temperature mode settings for different devices have been added to the profile
- The problems with miners having a “+” in their names (L3+, L3++ и T9+) have been rectified

👨‍💻 Installation
- The problems with the installation of the program on Windows 7, 8, and 8.1 have been rectified
- The test for dependencies has been added: if any of the standard components of the operating system are missing, the program will inform you of it

👨‍👨‍👧 A new section: "User Profiles"
- The possibility to set up two-factor authentication has been added
- The possibility to change the e-mail address for notifications has been added
- The possibility to change the upper and lower temperature boundary for the chip and board upon reaching which the notifications will be sent has been added

💰 The "Miners" section
- Simultaneous display of temperature for the chip and board has been added
- Color indication of temperature has been added: green (all is well) and red (a threshold value, the program is taking actions for rectifying the problem)
- Support for Antminer T9+, A3, and Whatsminer M3 miners has been added
- Display of host names has been added, in the case when they contain information about the miner’s location
- Now you can view active and inactive miners separately
- Statistics on inactive miners has been added: errors, operation time, and shutdown time
- Now the program can analyze the maximum temperature of the board and the maximum temperature of the chip separately, which allows it to make more precise and correct decisions
- Now the miner’s operating capacity is taken into consideration when it is launched, therefore if it is faulty and cannot operate at full capacity, the program does not try to rectify it

📈 The "Statistics" section
- Now the program displays the speed and draws plots separately for each algorithm used by the miner

🔐 The "Access" section
- Now the program can enable the compliance automatically
- In case if the automation does not work, we have simplified the manual installation mode

Thank you for your support!