15202
zf base
custom dial
custom hands（edge polished）
deep Crystal
first link flex
+
full watch Wg Warp

For rough and uneven surfaces of the dial, in order to ensure a shiny visual effect, it is especially recommended to clean it with a cleaning agent before installation and dry it before installation.
Because there is some dust on the 16202bc dial when it leaves the factory, which is hidden in uneven corners, it has to be cleaned before installation.
Cooperate with the polishing of the hands edge to make the front of the watch shiny enough😎😎😎

The same applies to Moissanite dials (they are not flat either, and need to be shiny), always clean them first💪

I recently studied two modification projects for 5711 and 5712.
1.CNC case edge polishing
2.crown retraction

1.
I have never recommended CNC cases 5711 and 5712 because they are expensive and have very little improvement. And CNC case endlinks usually have large gaps. However, many people still prefer CNC side shapes. The good news is that I can achieve the same properties at a very low price through polishing and remade cases. It's time to say goodbye to the expensive CNC 5712 5711 case.

I have learned about the modification of 5712 and upgraded the polishing of 5712CNC case to ensure consistency between the PPF case and CNC case on the side.(But it will be much cheaper than CNC cases😂😂)

2.
At the same time, 5712 crown modification was carried out to retract the crown of the watch without creating a gap, so don't worry about waterproof issues.

During crown retraction, the tube was slightly adjusted, so there is no need to worry about the movement, and all functions are normal.😁

show up some super Franken watches

116503

with gen
dial
hands
Crystal
18k yg bezel


116509

with gen
dial
hands
Crystal
18kwg bezel


All in stock, with the best prices
😋😋😋