Ah hell nah I have just uncovered an edge case that has slipped through testing 😭

The disconnect and reconnect issue can still occur when the phone battery is very low (like 2-1% low) and at that time, the kernel shuts down one of the phone's big cpu cores to save battery. When forcing that big cpu core back online via FKM it does not occur, as such, this fix needs both big cores online or else it'll disconnect and reconnect.

TL:DR The disconnect and reconnect issue can still happen if you're charging your phone at very low battery levels like <5%!

Just disclosing this to you all for honesty sake. I'm sorry that I couldn't fix it completely 😔

Starting from next updates for STRIX-Revived, there will be the following changes

1. KSU and NSU variants will be now all into 1 zip. Just like how can choose which dtbo to be installed, you will soon to be able to choose which boot image to flash, either one with KSU + SUSFS or the other without KSU. As given, expect a much larger zip size (~33 MB)

2. To accommodate all the shenanigans caused by ebpf changes and incompatibility with certain ROMs like Stock MIUI and A14 QPR1, there will be now 3 variants with each intended for other ROMs

* [UNIVER] = Universal variant, it is the current way STRIX-Revived is working with 3 dtbos in one zip (oss, miui and alternative oss dtbo for pullkit tree), supports up A15 pre-QPR1. A15 QPR1 and Stock MIUI will not be supported by this variant.

* [enAOSP] = enhanced AOSP variant, STRIX-Revived that has all the changes needed for AOSP ROMs only with support up to A15 QPR1 with only 1 oss dtbo in zip. All MIUI ROMs, Pulkit tree ROMs (until pulkit updates his tree for A15) and A14 QPR1 will not be supported by this variant.

* [leMIUI] = legacy MIUI variant, STRIX-Revived that has all the changes needed for A14 QPR2+ dropped and will support up to only A14 QPR1 (which is most usual A14 HyperOS ports is at) and only 1 miui dtbo. A15 HyperOS ports and ALL AOSP ROMs (expect A11 ROMs if you're old 👴) will not be supported by this variant.

This has been found to be the only way to satisfy all ROMs and their incompatiables with ebpf changes, the alternative would have been to completely drop MIUI support and tell A14 QPR1 peeps that they're out of luck. I think I did a good decision taking the harder route and I hope you all appreciate it ❤️

STRIX-Revived Staging 20250121

* Initial POC of KSU and NSU variants unification and initial release of [UNIVER] variant
* Attempt to fix ir blaster for MIUI while keeping the fix needed for AOSP (aryan's tree)
* Miscellaneous debloating and upstreaming changes

A15 QPR1 AOSP and legacy MIUI ROMs are not supported.

I'll release [enAOSP] and [leMIUI] variants if all goes well with [UNIVER] staging build. Your patience and feedback will be appreciated

Poll results looking very promising 😄

Note: IR Blaster maybe still broken for Pulkit tree AOSP ROMs, I'll try to fix it before stable release 🙏

(If only the peeps whom voted No on AOSP can confirm to me they're on pulkit tree ROMs)

I'm serious
If you voted no on AOSP and you're in a pulkit tree ROM (TPP, LOS-EXT, Pulkit's LOS, etc..) please DM me ASAP🤞

ln8k Hotfix will be reverted again due to causing kernel panic/soft reboots for bq charger I'm sorry 😔

PSA: Want an A15 QPR1 ROM and still use kernels that haven't even updated for A15 QPR1?

I recommend VOS 4.1

Need peeps whom are in HyperOS 2.0 ports who experience CC animations slow down in 120hz when using STRIX-Revived/yVy

DM me ploz🙏

No one?

Last poll before finally an update for STRIX-Revived

Note: Higher version number does not always mean better 🤭

Anyhow, for the next release, I have *definitely* fixed the following issues below:

* LN8K disconnect and reconnect + BQ soft reboots
* IR Blaster only working for (aryan's tree) AOSP (unsure for pulkit because no testers)
* Sluggishness and less smoothness