Water settling at the bottom of pots can lead to root rot. To combat this problem, cut up old sponges and put them in the bottom of the pot. The sponges retain moisture and create necessary air space. They also help prevent water from flushing out the bottom. The sponge acts as a water reserve and keeps soil moist longer.
https://t.me/life_hacks3

All you need is an old toothbrush and a little toothpaste to get your old sneakers looking like new! Non-gel white toothpaste works great for cleaning white-soled sneakers (colored toothpaste may stain rather than clean sneakers). Apply toothpaste to an old toothbrush and then work the paste into the dirty spots. Leave the toothpaste on the shoes for about ten minutes, and then wipe it off with a damp towel. Repeat the process if necessary.
https://t.me/life_hacks3

“I do a lot of finish-sanding freehand, without a sandpaper block, so I can smooth edges and get into nooks and crannies. But the finer grits are usually bonded to thinner paper and, at least for me, the paper is too thin and ends up tearing long before the grit wears out. So I apply duct tape to the back of the sandpaper. The sandpaper is still flexible enough to sand a tight radius and it’s far more durable. You can use this super-strong sandpaper like a shoeshine rag.” — Chuck Merchant
https://t.me/life_hacks3

To make your otherwise fragile phone charger last for more than a couple of weeks, try out this simple hack! Start by removing the spring from a pen. Next, stretch one end of the spring out a bit so it can fit around the charger cable. You might need to use pliers for this. Now, wind the spring around the cable until it is completely on the charger cable. Next, take appropriately sized heat shrink tubing and slip it over the phone charger and spring. Use a lighter to warm the heat shrink tubing until it conforms around the charger and spring. This simple hack will keep the cord from breaking any further or from even breaking in the first place!
https://t.me/life_hacks3

Everyone who has ever swept the floor with a standard broom and dustpan knows about that annoying line of dust. It’s the line that just won’t disappear no matter how many times you try and sweep it up. To get rid of this annoying line, simply tape the front of the dustpan to the floor with blue painters tape, so no residue will be left on the floor. It will seal and cover the gap between the floor and your pan.
https://t.me/life_hacks3

Make Your Own Ice Pack
Ice packs are a great way to keep your lunch cool, but they’re a bit expensive if you’re in the habit of losing them. This DIY ice pack hack is reusable, so it is good for the environment as well.
First, purchase an inexpensive pack of sponges or just find some old ones around the house. Grab a big bowl of water and let the sponges completely soak up as much water as they possibly can. After soaking the sponges, put each sponge in a small sandwich bag with a zip close. These bags serve two purposes. First, as the ice melts, the bag contains the water so it doesn’t make a mess in your lunch bag. Second, keeping the water contained allows the melted sponge to reabsorb the water so it is ready to refreeze for the next day. Now, freeze the wet and bagged sponges overnight. In the morning, all you need to do is toss the ice pack into your lunch container.
https://t.me/life_hacks3

DIY Car Mats
One simple way to keep your car clean is to cut scraps of old carpet to fit on the floor as mats.  We found our carpet scraps for less than $2 at Home Depot. And when the DIY carpet scraps inevitably get all dirty with mushy winter snow or summer sand, you could either give them a wash or toss them out and make more.
A word of caution, do not put these DIY car mats on the driver’s side of the car unless grippers are attached on the bottom side to ensure that the mat does not slip forward while driving.
https://t.me/life_hacks3

Dents in wood surfaces can be annoying. But fret not, they can be fixed! Simply soak a washcloth in water and ring it out a bit so it’s not sopping wet. Put the damp washcloth on the affected area. The water will wick through the wood, and that’s fine. Now, with your iron on its highest setting, place it on the damp washcloth over the affected area, and make small movements back and forth and in circles. Press down firmly and continue until your washcloth is dry. It won’t take long to evaporate. At this point, the wood fibers are absorbing the water and should expand back to where they were originally. Continue this process and repeat by adding more water until the dents rise up to be flush with the rest of the material.
https://t.me/life_hacks3

A staple remover has perfectly sized thin teeth that make them perfect to easily slide between the rings of a key ring. When you clamp them down, it spreads the key rings apart and makes it easy to slide a new key on. This saves you the hassle of trying to pry open the key ring with your nails.
https://t.me/life_hacks3

Support a Tension Rod with Water Bottle Caps
“My wife sews kids clothes and uses a curtain tension rod to hang them in a closet. She explained to me one day that the pole was frequently slipping and falling down. So, I searched and found an object that could be screwed into the wall and would fit around the ends of the tension rod: water bottle caps.
I used drywall screws to secure two water bottle caps into studs in the closet walls, and then I mounted the tension rod inside the bottle caps. The lip on each cap provides just enough support for the tension rod, so it doesn’t fall down anymore.” — Rodney Sheets
https://t.me/life_hacks3

Coat Your Snow Shovel with Car Wax
Shoveling snow can be frustrating enough, but when heavy snow sticks or freezes in clumps on the shovel, it can make the job even more difficult! You can avoid this issue by first coating your shovel with car wax before heading out to clear your driveway and walking paths.
This tip works best with metal shovels: Follow the application instructions on the car wax package. Generally, car wax is applied in a thin layer using a damp cloth, allowed to dry, and then buffed off with a dry cloth. This leaves the shovel clean and lubricated, so the snow and ice won’t stick!
https://t.me/life_hacks3

Find Your Lost Items
Everyone knows how annoying it is when you can’t seem to find a dropped pill or the back of an earring. So how do you find these items quickly and easily? Use your vacuum. Here’s the trick; before you turn the vacuum on, cut off the end of a nylon and secure it on the end of your vacuum hose with a rubber band. 
https://t.me/life_hacks3

Erase Permanent Marker on a Dry Erase Board
Who hasn’t accidentally written on a white board with a permanent marker? Luckily, it’s easier to remove than you think. Simply draw over your permanent marker artwork with a dry erase marker, and then wipe the marks away with an eraser or dry cloth. Your dry erase board will be good as new!
https://t.me/life_hacks3

Fix Wobbly Furniture with a Penny
Need to shim a wobbly bench or table, but don’t have time to run to the home center for furniture feet? No worries, just reach for your pocket change!
You can use a coin to shim wobbly furniture in a pinch. Use hot glue to attach the coin to the problem area, adding additional coins as needed. Coins work well as a temporary fix because they come in a variety of thicknesses and cost less than a dollar!
https://t.me/life_hacks3

Write Notes on the Washer
When you put a load of clothes into your washing machine, use a dry-erase marker to note on the lid which items should not go into the dryer. That way, whoever switches the load from the washing machine to the dryer will know which items to leave out for line drying.
The enamel finish on most washing machine lids is similar to a whiteboard, and dry-erase markers can be removed easily with a dry paper towel.
https://t.me/life_hacks3

Magnetized Drill Hack
I like to keep screws very close at hand when I’m working on a project. How close? I stick them right to my drill. Some drills are equipped with a magnetized portion for this purpose, but if yours isn’t, here’s an easy fix. Hot glue a rare earth magnet to the back of your drill and slap a few screws on it. For small tasks, I don’t even need a tool belt. – Lucas Kuck
https://t.me/life_hacks3

Bring Dead Sharpies Back to Life
When it comes to workshop problems, dried-out Sharpies aren’t major. But they are annoying when you can’t find another one to mark your measurements or project notes.
To bring your permanent marker back to life, simply remove the back from the maker. This will be different for each brand of permanent marker, for Sharpies simply remove the back nib. Next, deposit a few drops of isopropyl “rubbing” alcohol onto the felt material inside. Shake the marker a bit to ensure the rubbing alcohol is absorbed. It’s the solvent that the ink is mixed with that dries out first, making the pigment unable to flow. Once the felt absorbs the rubbing alcohol for a couple of minutes the marker will be practically good as new!
https://t.me/life_hacks3

Use a Ceramic Mug as a Sharpening Stone
The bottom of most ceramic coffee mugs have a flat, unglazed ring that is the perfect surface for giving that dull knife or blade a quick sharpening. And if you find yourself in need of sharpening a utility knife, pocket blade or scissors and don’t have access to a sharpening stone, you can simply flip over a ceramic coffee mug and use the outer edge of the bottom, the non-glazed part, as an emergency sharpening stone.
Just run the blade across the bottom of the mug at a 45-degree angle, working from the one end of the blade to the tip. Next, slide the blade downward in one direction, keeping your fingers out of the way as you work.
This isn’t a perfect solution for continually sharpening your blades, but if you need to quickly sharpen and clean up the edge of a blade this method will do in a pinch. We do recommend eventually investing in a blade sharpening kit. 
https://t.me/life_hacks3