As Ethernet became the world-wide standard for wired networking, there was one nagging problem. You already have to plug in the network cable. But then you have to also plug …read more (https://hackaday.com/2025/10/11/entering-the-wild-world-of-power-over-ethernet/)

A Deep Dive into The Coolness That Was CRT Projectors
https://hackaday.com/2025/10/11/a-deep-dive-into-the-coolness-that-was-crt-projectors/

CRT monitors: there’s nothing quite like ’em. But did you know that video projectors used to use CRTs? A trio of monochrome CRTs, in fact: one for each color; red, …read more (https://hackaday.com/2025/10/11/a-deep-dive-into-the-coolness-that-was-crt-projectors/)

Bose SoundTouch Smart WiFi Speakers are about to go Dumb
https://hackaday.com/2025/10/11/bose-soundtouch-smart-wifi-speakers-are-about-to-go-dumb/

Bose SoundTouch speakers were introduced in 2013, offering the ability to connect to online streaming services and play back audio on multiple speakers simultaneously using the accompanying mobile app. Now …read more (https://hackaday.com/2025/10/11/bose-soundtouch-smart-wifi-speakers-are-about-to-go-dumb/)

Save Your USB-C Plugs From Oblivion
https://hackaday.com/2025/10/11/save-your-usb-c-plugs-from-oblivion/

USB-C as the “One Cable To Rule Them All” has certainly been a success. While USB-A is still around for now, most of us have breathed a hefty sigh of …read more (https://hackaday.com/2025/10/11/save-your-usb-c-plugs-from-oblivion/)

The Subtle Art of Letterform Design
https://hackaday.com/2025/10/12/the-subtle-art-of-letterform-design/

Typeface (such as Times New Roman) refers to the design that gives a set of letters, numbers, and symbols their signature “look”. Font, on the other hand, is a specific …read more (https://hackaday.com/2025/10/12/the-subtle-art-of-letterform-design/)

Removing Infill to Make 3D Printed Parts Much Stronger
https://hackaday.com/2025/10/12/removing-infill-to-make-3d-printed-parts-much-stronger/

When it comes to FDM 3D prints and making them stronger, most of the focus is on the outer walls and factors like their layer adhesion. However, paying some attention …read more (https://hackaday.com/2025/10/12/removing-infill-to-make-3d-printed-parts-much-stronger/)

Tubeless X-Ray Runs on Patience
https://hackaday.com/2025/10/12/tubeless-x-ray-runs-on-patience/

Every time we check in on [Project326], he’s doing something different with X-rays. This week, he has a passive X-ray imager. On paper, it looks great. No special tube is …read more (https://hackaday.com/2025/10/12/tubeless-x-ray-runs-on-patience/)