🚨 CVE-2026-33997
Moby is an open source container framework. Prior to version 29.3.1, a security vulnerability has been detected that allows plugins privilege validation to be bypassed during docker plugin install. Due to an error in the daemon's privilege comparison logic, the daemon may incorrectly accept a privilege set that differs from the one approved by the user. Plugins that request exactly one privilege are also affected, because no comparison is performed at all. This issue has been patched in version 29.3.1.

🎖@cveNotify

🚨 CVE-2026-32280
During chain building, the amount of work that is done is not correctly limited when a large number of intermediate certificates are passed in VerifyOptions.Intermediates, which can lead to a denial of service. This affects both direct users of crypto/x509 and users of crypto/tls.

🎖@cveNotify

🚨 CVE-2026-32283
If one side of the TLS connection sends multiple key update messages post-handshake in a single record, the connection can deadlock, causing uncontrolled consumption of resources. This can lead to a denial of service. This only affects TLS 1.3.

🎖@cveNotify

🚨 CVE-2026-35469
spdystream is a Go library for multiplexing streams over SPDY connections. In versions 0.5.0 and below, the SPDY/3 frame parser does not validate attacker-controlled counts and lengths before allocating memory. Three allocation paths are affected: the SETTINGS frame entry count, the header count in parseHeaderValueBlock, and individual header field sizes — all read as 32-bit integers and used directly as allocation sizes with no bounds checking. Because SPDY header blocks are zlib-compressed, a small on-the-wire payload can decompress into large attacker-controlled values. A remote peer that can send SPDY frames to a service using spdystream can exhaust process memory and cause an out-of-memory crash with a single crafted control frame. This issue has been fixed in version 0.5.1.

🎖@cveNotify

🚨 CVE-2026-31488
In the Linux kernel, the following vulnerability has been resolved:

drm/amd/display: Do not skip unrelated mode changes in DSC validation

Starting with commit 17ce8a6907f7 ("drm/amd/display: Add dsc pre-validation in
atomic check"), amdgpu resets the CRTC state mode_changed flag to false when
recomputing the DSC configuration results in no timing change for a particular
stream.

However, this is incorrect in scenarios where a change in MST/DSC configuration
happens in the same KMS commit as another (unrelated) mode change. For example,
the integrated panel of a laptop may be configured differently (e.g., HDR
enabled/disabled) depending on whether external screens are attached. In this
case, plugging in external DP-MST screens may result in the mode_changed flag
being dropped incorrectly for the integrated panel if its DSC configuration
did not change during precomputation in pre_validate_dsc().

At this point, however, dm_update_crtc_state() has already created new streams
for CRTCs with DSC-independent mode changes. In turn,
amdgpu_dm_commit_streams() will never release the old stream, resulting in a
memory leak. amdgpu_dm_atomic_commit_tail() will never acquire a reference to
the new stream either, which manifests as a use-after-free when the stream gets
disabled later on:

BUG: KASAN: use-after-free in dc_stream_release+0x25/0x90 [amdgpu]
Write of size 4 at addr ffff88813d836524 by task kworker/9:9/29977

Workqueue: events drm_mode_rmfb_work_fn
Call Trace:
<TASK>
dump_stack_lvl+0x6e/0xa0
print_address_description.constprop.0+0x88/0x320
? dc_stream_release+0x25/0x90 [amdgpu]
print_report+0xfc/0x1ff
? srso_alias_return_thunk+0x5/0xfbef5
? __virt_addr_valid+0x225/0x4e0
? dc_stream_release+0x25/0x90 [amdgpu]
kasan_report+0xe1/0x180
? dc_stream_release+0x25/0x90 [amdgpu]
kasan_check_range+0x125/0x200
dc_stream_release+0x25/0x90 [amdgpu]
dc_state_destruct+0x14d/0x5c0 [amdgpu]
dc_state_release.part.0+0x4e/0x130 [amdgpu]
dm_atomic_destroy_state+0x3f/0x70 [amdgpu]
drm_atomic_state_default_clear+0x8ee/0xf30
? drm_mode_object_put.part.0+0xb1/0x130
__drm_atomic_state_free+0x15c/0x2d0
atomic_remove_fb+0x67e/0x980

Since there is no reliable way of figuring out whether a CRTC has unrelated
mode changes pending at the time of DSC validation, remember the value of the
mode_changed flag from before the point where a CRTC was marked as potentially
affected by a change in DSC configuration. Reset the mode_changed flag to this
earlier value instead in pre_validate_dsc().

(cherry picked from commit cc7c7121ae082b7b82891baa7280f1ff2608f22b)

🎖@cveNotify

🚨 CVE-2026-33811
When using LookupCNAME with the cgo DNS resolver, a very long CNAME response can trigger a double-free of C memory and a crash.

🎖@cveNotify

🚨 CVE-2026-33814
When processing HTTP/2 SETTINGS frames, transport will enter an infinite loop of writing CONTINUATION frames if it receives a SETTINGS_MAX_FRAME_SIZE with a value of 0.

🎖@cveNotify

🚨 CVE-2026-39820
Well-crafted inputs reaching ParseAddress, ParseAddressList, and ParseDate were able to trigger excessive CPU exhaustion and memory allocations.

🎖@cveNotify

🚨 CVE-2026-42499
Pathological inputs could cause DoS through consumePhrase when parsing an email address according to RFC 5322.

🎖@cveNotify

🚨 CVE-2026-42006
An attacker can cause uncontrolled memory usage with excessive bracing over IMAP. The fix in CVE-2026-27857 was incomplete, only blocking one way of doing this, so there was still another way left open. In particular, the fix was for closing braces, but you could still use open braces to bypass the limit. Using excessive bracing, attacker can cause memory usage up to configured memory limit. Install fixed version, or configure vsz_limit for imap process to low value. No publicly available exploits are known.

🎖@cveNotify

🚨 CVE-2026-44432
urllib3 is an HTTP client library for Python. From 2.6.0 to before 2.7.0, urllib3 could decompress the whole response instead of the requested portion (1) during the second HTTPResponse.read(amt=N) call when the response was decompressed using the official Brotli library or (2) when HTTPResponse.drain_conn() was called after the response had been read and decompressed partially (compression algorithm did not matter here). These issues could cause urllib3 to fully decode a small amount of highly compressed data in a single operation. This could result in excessive resource consumption (high CPU usage and massive memory allocation for the decompressed data) on the client side. This vulnerability is fixed in 2.7.0.

🎖@cveNotify

🚨 CVE-2026-42561
Python-Multipart is a streaming multipart parser for Python. Prior to 0.0.27, python-multipart has a denial of service vulnerability in multipart part header parsing. When parsing multipart/form-data, MultipartParser previously had no limit on the number of part headers or the size of an individual part header. An attacker could send a request with either many repeated headers without terminating the header block or a single very large header value, causing excessive CPU work before request rejection or completion. This vulnerability is fixed in 0.0.27.

🎖@cveNotify

🚨 CVE-2026-6473
Integer wraparound in multiple PostgreSQL server features allows an unprivileged database user to cause the server to undersize an allocation and write out-of-bounds. This may execute arbitrary code as the operating system user running the database. In applications that pass gigabyte-scale user inputs to the relevant database functions, the application input provider may achieve a segmentation fault. Versions before PostgreSQL 18.4, 17.10, 16.14, 15.18, and 14.23 are affected.

🎖@cveNotify

🚨 CVE-2026-6477
Use of inherently dangerous function PQfn(..., result_is_int=0, ...) in PostgreSQL libpq lo_export(), lo_read(), lo_lseek64(), and lo_tell64() functions allows the server superuser to overwrite a client stack buffer with an arbitrarily-large response. Like gets(), PQfn(..., result_is_int=0, ...) stores arbitrary-length, server-determined data into a buffer of unspecified size. Because both the \lo_export command in psql and pg_dump call lo_read(), the server superuser can overwrite pg_dump or psql stack memory. Versions before PostgreSQL 18.4, 17.10, 16.14, 15.18, and 14.23 are affected.

🎖@cveNotify

🚨 CVE-2026-6478
Covert timing channel in comparison of MD5-hashed password in PostgreSQL authentication allows an attacker to recover user credentials sufficient to authenticate. This does not affect scram-sha-256 passwords, the default in all supported releases. However, current databases may have MD5-hashed passwords originating in upgrades from PostgreSQL 13 or earlier. Versions before PostgreSQL 18.4, 17.10, 16.14, 15.18, and 14.23 are affected.

🎖@cveNotify

🚨 CVE-2026-39828
When an SSH server authentication callback returned PartialSuccessError with non-nil Permissions, those permissions were silently discarded, potentially dropping certificate restrictions such as force-command after a second factor succeeded. Returning non-nil Permissions with PartialSuccessError now results in a connection error.

🎖@cveNotify

🚨 CVE-2026-39830
A malicious SSH peer could send unsolicited global request responses to fill an internal buffer, blocking the connection's read loop. The blocked goroutine could not be released by calling Close(), resulting in a resource leak per connection. Unsolicited global responses are now discarded.

🎖@cveNotify

🚨 CVE-2026-39832
When adding a key to a remote agent constraint extensions such as restrict-destination-v00@openssh.com were not serialized in the request. Destination restrictions were silently stripped when forwarding keys, allowing unrestricted use of the key on the remote host. The client now serializes all constraint extensions. Additionally, the in-memory keyring returned by NewKeyring() now rejects keys with unsupported constraint extensions instead of silently ignoring them.

🎖@cveNotify

🚨 CVE-2026-39835
SSH servers which use CertChecker as a public key callback without setting IsUserAuthority or IsHostAuthority could be caused to panic by a client presenting a certificate. CertChecker now returns an error instead of panicking when these callbacks are nil.

🎖@cveNotify

🚨 CVE-2026-9256
NGINX Plus and NGINX Open Source have a vulnerability in the ngx_http_rewrite_module module. This vulnerability exists when a rewrite directive uses a regex pattern with distinct, overlapping Perl-Compatible Regular Expression (PCRE) captures (for example, ^/((.*))$) and a replacement string that references multiple such captures (for example, $1$2) in a redirect or arguments context. An unauthenticated attacker along with conditions beyond their control can exploit this vulnerability by sending crafted HTTP requests. This may cause a heap buffer overflow in the NGINX worker process leading to a restart. Additionally, attackers can execute code on systems with Address Space Layout Randomization (ASLR) disabled or when the attacker can bypass ASLR.


Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated.

🎖@cveNotify

🚨 CVE-2026-39821
The ToASCII and ToUnicode functions incorrectly accept Punycode-encoded labels that decode to an ASCII-only label. For example, ToUnicode("xn--example-.com") incorrectly returns the name "example.com" rather than an error. This behavior can lead to privilege escalation in programs using the idna package. For example, a program which performs privilege checks on the ASCII hostname may reject "example.com" but permit "xn--example-.com". If that program subsequently converts the ASCII hostname to Unicode, it will inadvertently permits access to the Unicode name "example.com".

🎖@cveNotify