docker pull docker.1ms.run/whyyour/qinglong:debian

{
    "inbounds": [
        {
            // 此处省略具体 inbound 配置
            "tag": "inbound-xxx"
        }
    ],
    "outbounds": [
        {
            "protocol": "freedom",
            "streamSettings": {
                "sockopt": {
                    "tcpFastOpen": true,
                    "interface": "WARP"// 指定使用名为 WARP 的网卡
                }
            },
            "settings": {
                "domainStrategy": "AsIs"
            },
            "tag": "my-warp"
        }
    ],
    "routing": {
        "rules": [
            {// 将 inbound 和 outbound 通过路由绑定：inbound-xxx -> my-warp
                "inboundTag": [
                    "inbound-xxx"
                ],
                "network": "tcp,udp",
                "outboundTag": "my-warp",
                "type": "field"
            }
        ]
    }
}

root@MiserlyBlushing-VM:~# cat /etc/network/interfaces
source /etc/network/interfaces.d/*
# Generated by SolusVM
auto lo
iface lo inet loopback

auto eth0
iface eth0 inet static
   address xx
   netmask 255.255.255.0
   gateway xx
   dns-nameservers 8.8.8.8 8.8.4.4

iface eth0 inet6 static
   address xx
   netmask 64
   gateway xx
   metric 100

auto he-ipv6
iface he-ipv6 inet6 v4tunnel
    address xx
    netmask 64
    endpoint xx
    local 4xx
    ttl 255
    gateway xx
    # 设置更高的metric值（数值越大优先级越低）
    metric 200

network:
  version: 2
  ethernets:
    eth0:
      match:
        macaddress: "xx"
      addresses:
      - "xx/64"
      nameservers:
        addresses:
        - 2606:4700:4700::1111
        - 2001:4860:4860::8888
      dhcp4: true
      accept-ra: false
      set-name: "eth0"
      routes:
      - to: "default"
        via: "xx"
        metric: 100
  tunnels:
    he-ipv6:
      mode: sit
      remote: xx
      local: xx
      addresses:
        - "xx/64"
      routes:
        - to: default
          via: "xx"
          metric: 1000

我的 Linux机器的 netplan 配置是这样：  
  
[netplan 文件]

我还在想在此基础之上，添加一个 he.net tunnel broker， 官网给出的配置是这样的    

[he tunnel broker 配置]

而且我想让这个 tunnel broker 的优先级别最低，一般不让他走这个ip。那我应该怎么配置？

如果想加入 routed/64 的 ip，
那么可以在以上 netplan 的配置基础上，原 client ipv6 后面另起一行，加入 routed/64 的 ip 即可，去一个尾号大点的，比如aedf。client ipv6 不能删掉，必须留着。
这样这个界面在访问外部 ip 时，默认走这个 routed/64 ip