Power System Engineering Research World
258 subscribers
48 photos
1 video
17 files
21 links
Welcome to Power System Engineering Research World (PSEnggRW) Telegram Channel

▪️▪️▪️▪️
⚡️Commitment to survive for the Electrical⚡️World,
⚡️Commitment to explore for the Electrical World⚡️
Download Telegram
Engine Control Room (Pict -9),
#picture_of_the_day_PSEnggRW

—————————————
⚡️Support & Contact Us ⚡️Donate (₹)
#mcqs_transmission_and_distribution (Page -1),
Scroll Down ⤵️⤵️⤵️⤵️
Overhead system can be designed for operation up to

A. 11 kV
B. 33 kV
C. 66 kV
D. 400 kV

Answer: Option D

The underground system cannot be operated above 66 kV because of insulation difficulties but overhead system can be designed for operation up to 400 kV or higher even.
——————————————————————————————
By which of the following a bus-bar is rated?

A. Current only
B. Current and voltage
C. Current, voltage and frequency
D. Current, voltage, frequency and short time current

Answer: Option D
Which of the following equipment, for regulating the voltage in distribution feeder, will be most economical?
Anonymous Quiz
8%
A. Static condenser
31%
B. Synchronous condenser
46%
C. Tap changing transformer
15%
D. Booster transformer
The frequency of voltage generated, in case of generators, can be increased by

A. Using reactors
B. Increasing the load
C. Adjusting the governor
D. Reducing the terminal voltage

Answer: Option C
In aluminium conductors, steel core is provided to

A. Compensate for skin effect
B. Neutralise proximity effect
C. Reduce line inductance
D. Increase the tensile strength

Answer: Option D
—————————————————————————-
A 3-phase 4-wire system is commonly used on

A. Primary transmission
B. Secondary transmission
C. Primary distribution
D. Secondary distribution

Answer: Option D
Pin type insulators are generally not used for voltages beyond
Anonymous Quiz
31%
A. 1 kV
31%
B. 11 kV
6%
C. 22 kV
31%
D. 33 kV
Which of the following is usually not the generating voltage?

A. 6.6 kV
B. 8.8 kV
C. 11 kV
D. 13.2 kV

Answer: Option B
——————————————————
When the interconnector between two stations has large reactance

A. The transfer of power will take place with voltage fluctuation and noise
B. The transfer of power will take place with least loss
C. The stations will fall out of step because of large angular displacement between the stations
D. None of the above

Answer: Option C
====End of mcqs_transmission_and_distribution (Page -1)====
Electric Pole (Pict -10),
#picture_of_the_day_PSEnggRW
———————————————-
You can't stand on two boats(or Group),
Stand by Only on One boat (or One Group) is the Destiny of Success; Follow to All⚡️🔬🔌📚s, Choose to One🔬⚡️ - BGSPlusLYB
EEEW Edu Group
——
StudyWell ⚡️🔬🔌📚 & Contribute To BeheraGreenShinePlusLYB Electrical and Electronics Engineering World Education Group,
- BGSPlusLYB EEEW Edu Group
Enhancing Transmission Line Performance:
Using Simulation to Optimize Design (Pict -11),
#picture_of_the_day_PSEnggRW
Current Transformer (Pict -12),
#picture_of_the_day_PSEnggRW
Capacitor Voltage Transformers (Pict -13),
#picture_of_the_day_PSEnggRW
#mcqs_earthing_or_grounding (Page -2),
Scroll Down ⤵️⤵️⤵️⤵️
The size of the earth or ground wire is based on the

A. maximum fault current carrying through the ground wire
B. rated current carrying capacity of the service line
C. depends on the soil resistance
D. both (A) and (C)

Answer: Option D

—————————————
⚡️Support & Contact Us ⚡️Donate (₹)
1
====End of mcqs_earthing_or_grounding (Page -2)====
This media is not supported in your browser
VIEW IN TELEGRAM
👍1