Samsung A34 5g software update after touch not work
Solution or file available any bit

Shell shell


Easy jtag plus box red 2nd generation

Ufs adapter bga 254 6in1

Emmc shocket full kit set 13in1

Full setup shell

Operation: Connect to Z3X EasyJtagPlus

Setting Interface to EasyJtag2/UFS ISP
Setting IO Levels to Low
Setting Frequence to 66 Mhz

Socket Information :
Socket Mark: EasyJTAG UFS Socket BGA-254 by EasyJTAG 31.12.22
Socket Serial: 0123A862FFB9B569EE
Socket Type: UFS_SOCKET_BGA_254
UFS Power Information :
Mode: Low, VCC: 3308 mV, VCCQ2: 1938 mV
UFS Device Information :
UFS Manufacturer: SAMSUNG, UFS ProductName: KMAG9001PM-B814
UFS Version: 3.1, UFS OemID: SAMSUNG_OEM_ID, UFS FirmVersion: 5.00, UFS SerialNumber: 55bcc0685019
Maximum Number of LUs: 8, Number of LUs found: 4, Number of WLUs found: 1, LUs Re-configure: Enabled
RPMB Counter: 3306
UFS LUN 0 (Main Boot A) Capacity: 4 MB (000000400000)
UFS LUN 1 (Boot B) Capacity: 4 MB (000000400000)
UFS LUN 2 Capacity: 122028 MB (001DCAC00000)
UFS LUN 3 Capacity: 4 MB (000000400000)
UFS card does not support type of memory for LUN 0. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 1. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 2. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 3. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 4. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 5. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 6. This value will be replaced by the first supported
UFS card does not support type of memory for LUN 7. This value will be replaced by the first supported

Device Life Time Estimation B: 0x02 10% - 20% device life time used
Device Life Time Estimation A: 0x02 10% - 20% device life time used
Pre EOL information: 0x01 Normal (Consumed less then 80% of reserved block)

Backup saved: UFS_SAMSUNG_KMAG9001PM-B814_55bcc0685019_20250418_135931_config.ini (old backup)

Do not turn the socket before you press "Close Session" button

Connected successfully

Operation: Scan PartitionTable from Source (Vendor: Binary Read/Write)

Scanning soft partitions from LUN 0 (Main Boot A)
UFS_SWITCH_PART: START_LUN failed: -507 UIC: Link initialization fail
Error reading at address: 000000000000 , error: -700, API_UFS_LUN_NOT_SELECTED ... Retry #1

Canceled